Feed conversion ratio

Feed conversion ratio (FCR) is the ratio of inputs to outputs; it is the inverse of "feed efficiency" which is the ratio of outputs to inputs.^[2] FCR is widely used in hog and poultry production, while FE is used more commonly with cattle.^[2] Being a ratio the FCR is dimensionless, that is, it is not affected by the units of measurement used to determine the FCR.^[3]

FCR a function of the animal's genetics^[4] and age,^[5] the quality and ingredients of the feed,^[5] and the conditions in which the animal is kept,^[1][6] and storage and use of the feed by the farmworkers.^[7]

As a rule of thumb, the daily FCR is low for young animals (when relative growth is large) and increases for older animals (when relative growth tends to level out). However FCR is a poor basis to use for selecting animals to improve genetics, as that results in larger animals that cost more to feed; instead residual feed intake (RFI) is used which is independent of size.^[8] RFI uses for output the difference between actual intake and predicted intake based on an animal's body weight, weight gain, and composition.^[8][9]

The outputs portion may be calculated based on weight gained, on the whole animal at sale, or on the dressed product; with milk it may be normalized for fat and protein content.^[10]

As for the inputs portion, although FCR is commonly calculated using feed dry mass, it is sometimes calculated on an as-fed wet mass basis, (or in the case of grains and oilseeds, sometimes on a wet mass basis at standard moisture content), with feed moisture resulting in higher ratios.^[11]

Animals that have a low FCR are considered efficient users of feed. However, comparisons of FCR among different species may be of little significance unless the feeds involved are of similar quality and suitability.

As of 2013^[update] in the US, an FCR calculated on live weight gain of 4.5–7.5 was in the normal range with an FCR above 6 being typical.^[8] Divided by an average carcass yield of 62.2%, the typical carcass weight FCR is above 10. As of 2013^[update] FCRs had not changed much compared to other fields in the prior 30 years, especially compared to poultry which had improved feed efficiency by about 250% over the last 50 years.^[8]

The dairy industry traditionally didn't use FCR but in response to increasing concentration in the dairy industry and other livestock operations, the EPA updated its regulations in 2003 controlling manure and other waste releases produced by livestock operators.^{[12]: 11–11} In response the USDA began issuing guidance to dairy farmers about how to control inputs to better minimize manure output and to minimize harmful contents, as well as optimizing milk output.^[13][14]

In the US, the price of milk is based on the protein and fat content, so the FCR is often calculated to take that into account.^[15] Using an FCR calculated just on the weight of protein and fat, as of 2011^[update] an FCR of 13 was poor, and an FCR of 8 was very good.^[15]

Another method for dealing with pricing based on protein and fat, is using energy-corrected milk (ECM), which adds a factor to normalize assuming certain amounts of fat and protein in a final milk product; that formula is (0.327 x milk mass) + (12.95 x fat mass) + (7.2 x protein mass).^[11]

In the dairy industry, feed efficiency (ECM/intake) is often used instead of FCR (intake/ECM); an FE less than 1.3 is considered problematic.^[13][11]

FE based simply on the weight of milk is also used; an FE between 1.30 and 1.70 is normal.^[10]

Pigs have been kept to produce meat for 5,000 to 9,000 years.^[16] As of 2011^[update], pigs used commercially in the UK and Europe had an FCR, calculated using weight gain, of about 1 as piglets and ending about 3 at time of slaughter.^[5] As of 2012^[update] in Australia and using dressed weight for the output, a FCR calculated using weight of dressed meat of 4.5 was fair, 4.0 was considered "good", and 3.8, "very good".^[17]

The FCR of pigs is greatest up to the period, when pigs weigh 220 pounds. During this period, their FCR is 3.5.^[16] Their FCR begins increasing gradually after this period. For instance, in the US as of 2012^[update], commercial pigs had FCR calculated using weight gain, of 3.46 for while they weighed between 240 and 250 pounds, 3.65 between 250 and 260 pounds, 3.87 between 260 and 270 lbs, and 4.09 between 280 and 270 lbs.^[18]

Because FCR calculated on the basis of weight gained gets worse after pigs mature, as it takes more and more feed to drive growth, countries that have a culture of slaughtering pigs at very high weights, like Japan and Korea, have poor FCRs.^[5]

Some data for sheep illustrate variations in FCR. A FCR (kg feed dry matter intake per kg live mass gain) for lambs is often in the range of about 4 to 5 on high-concentrate rations,^[19][20][21] 5 to 6 on some forages of good quality,^[22] and more than 6 on feeds of lesser quality.^[23] On a diet of straw, which has a low metabolizable energy concentration, FCR of lambs may be as high as 40.^[24] Other things being equal, FCR tends to be higher for older lambs (e.g. 8 months) than younger lambs (e.g. 4 months).^[21]

As of 2011^[update] in the US, broiler chickens has an FCR of 1.6 based on body weight gain, and mature in 39 days.^[25] At around the same time the FCR based on weight gain for broilers in Brazil was 1.8.^[25] The global average in 2013 is around 2.0 for weight gain (live weight) and 2.8 for slaughtered meat (carcass weight).^[26]

For hens used in egg production in the US, as of 2011^[update] the FCR was about 2, with each hen laying about 330 eggs per year.^[25] When slaughtered, the world average layer flock as of 2013 yields a carcass FCR of 4.2, still much better than the average backyard chicken flock (FCR 9.2 for eggs, 14.6 for carcass).^[26]

From the early 1960s to 2011 in the US broiler growth rates doubled and their FCRs halved, mostly due to improvements in genetics and rapid dissemination of the improved chickens.^[25] The improvement in genetics for growing meat created challenges for farmers who breed the chickens that are raised by the broiler industry, as the genetics that cause fast growth decreased reproductive abilities.^[27]

In aquaculture, the fish feed for carnivorous fish commonly includes fish-derived products in the form of fishmeal and fish oil. There are therefore two ratios to be reported:^[28][29]

• The regular feed conversion ratio, i.e. output fish mass divided by total feed mass.
• The conversion ratio only taking into account the fish-based component of fish feed, called the FIFO ratio (or Fish In – Fish Out ratio). FIFO is fish in (the mass of harvested fish used to feed farmed fish) divided by fish out (mass of the resulting farmed fish).

FIFO is a way of expressing the contribution from harvested wild fish used in aquafeed compared with the amount of edible farmed fish, as a ratio. The fish used in fishmeal and fish oil production are not used for human consumption, but with their use as fishmeal and fish oil in aquafeed they contribute to global food production.

Fishmeal and fish oil inclusion rates in aquafeeds have shown a continual decline over time as aquaculture grows and more feed is produced, but with a finite annual supply of fishmeal and fish oil. Calculations have shown that the overall fed aquaculture FIFO declined from 0.63 in 2000 to 0.33 in 2010, and 0.22 in 2015. In 2015, therefore, approximately 4.55 kg of farmed fish was produced for every 1 kg of wild fish harvested and used in feed. (For Salmon & Trout, the FIFO ratios for 2000, 2010, and 2015 are: 2.57, 1.38, 0.82.)^[30]

As of 2015^[update] farm-raised Atlantic salmon had a commodified feed supply with four main suppliers, and an FCR of around 1.^[31] Tilapia is about 1.5,^[32] and as of 2013^[update] farmed catfish had a FCR of about 1.^[8]

It is possible for fish to have an FCR below 1 despite obvious energy losses in feed-to-meat conversion. Fish feed tends to be dry food with higher energy density than water-rich fish flesh.^[33]

For herbivorous and omnivorous fish like Chinese carp and tilapia, the plant-based feed yields much lower FCR compared to carnivorous kept on a partially fish-based diet, despite a decrease in overall resource use. The edible (fillet) FCR of tilapia is around 4.6 and the FCR of Chinese carp is around 4.9.^[34]

In India, rabbits raised for meat had an FCR of 2.5 to 3.0 on high grain diet and 3.5 to 4.0 on natural forage diet, without animal-feed grain.^[35]

In a global study, FAO estimated various feed conversion ratios, taking into account the diversity of feed material consumed by livestock.^[36][37] At global level, ruminants require 133 kg of dry matter per kg of protein while monogastrics require 30 kg.^[36][37] However, when considering human edible feed only, ruminants require 5.9 kg of feed to produce 1 kg of animal protein, while monogastrics require 15.8 kg.^[36][37] When looking at meat only, ruminants consume an average of 2.8 kg of human edible feed per kg of meat produced, while monogastrics need 3.2 kg.^[36][37] Finally, when accounting for the protein content of the feed, ruminant need an average of 0.6 kg of edible plant protein to produce 1 kg of animal protein while monogastric need 2 kg.^[36][37] This means that ruminants make a positive net contribution to the supply of edible protein for humans at global level.^[36][37]

Many alternatives to conventional animal meat sources have been proposed for higher efficiency, including insects, meat analogues, and cultured meats.^[34]

Although there are few studies of the feed conversion ratios of edible insects, the house cricket (Acheta domesticus) has been shown to have a FCR of 0.9 - 1.1 depending on diet composition.^[38] A more recent work gives an FCR of 1.9–2.4. Reasons contributing to such a low FCR include the whole body being used for food, the lack of internal temperature control (insects are poikilothermic), high fecundity and rate of maturation.^[34]

If one treats tofu as a meat, the FCR reaches as low as 0.29. The FCRs for less watery forms of meat analogues are unknown.^[34]

Although cultured meat has a potentially much lower land footprint required, its FCR is closer to poultry at around 4 (2-8). It has a high need for energy inputs.^[34]

• Entomophagy
• Food vs. feed
• Life-cycle assessment