Mack NR

Mack NR
Mack NR truck; Bridgehead, Bussum, Netherlands
Type	Cargo truck
Place of origin	United States
Production history
No. built	over 16,000 built
Specifications
Mass	9.2 ton (empty)
Length	8,200 mm (322.8 in)
Width	2,600 mm (102.4 in)
Height	2,500 mm (98.4 in)
Crew	1 driver
Armor	none
Main armament	.
Secondary armament	none
Engine	Mack-Lanova ED diesel engine, 6-cylinders 131 hp
Payload capacity	10 ton (cargo capacity)
Suspension	wheels, 6x6

The Mack NR was a heavy 6x4 cargo truck designed and produced in the 1940s by the American manufacturer Mack Trucks. It was used mainly by the British Army to transport cargo and materiel over long distances during World War II. The official U.S. Army designation was: Truck, 10 ton, 6x4, Cargo.^[1] Its G-number was (G-528).

Before the outbreak of World War II France had bought in United States 210 Mack EXBX heavy trucks for transporting tanks. The outcome of the Battle of France prevented the delivery of these trucks to France, and Great Britain received them instead.^{[citation needed]} The British Purchasing Commission acting in the United States contracted the provision of Mack heavy trucks for military use; this resulted in the NR series. Every order was given its own number even if the performance remained unchanged or the differences were minimal; this resulted in the NR-1 to NR-20 designations.^{[citation needed]}

In 1940 an initial order was placed with Mack for 90 heavy trucks in the 10-ton category under the designation NR-1.^[1] These trucks were similar to those provided to the British troops through the French order, but were not specifically equipped for tank transport. The NR-1 was a variant of a basic civilian version that was marketed in the 1930s by Mack; however with a solid grill to protect the radiator and headlamps, and an extra roof above the cab to prevent overheating. These vehicles were assigned to the Middle East and the Far East theatres. The trucks were powered by a six-cylinder Mack-Lanova ED engine which could deliver 131 HP at 2,000 rpm; driving a TR 12 Duplex transmission with five gears. The rear wheels, with tyre size 13.50-20, were the only with power, hence the 6x4 designation; the front wheels had a different tire size, namely 10.50-24,. The empty weight was just over 10 tons.^[1] The cost per vehicle was around $9,000.

The initial order was quickly followed by two follow-up orders, for the NR-2 and NR-3 models. The NR-2 was a military version of the Model 270 driver's cab and it differed in small details; this cab was used until the introduction of the open cabin. The British ordered 330 units of this model. In 1941 61 units of the NR-3 model were ordered; this was meant for long-distance transport in the Middle East by the logistics department of the British Army, the Royal Army Service Corps (RASC). The dimensions were 8.2 meters long, 2.6 meters wide and 2.5 meters high. The empty weight was 9.3 tons, and this version had a slightly different wheel size (11.00-24 front and 14.00-20 rear).^[1]

The NR-4 variant was like the Mack EXBX, a special version for tank transport. On August 21, 1941, an order was placed for 200 units.^[1] They were identical to the NR-3 but with a flat-floor cargo area, a winch, and ramps to upload the tank to the cargo area. The empty weight was about 11.7 metric tons, and the total weight load was less than 22.7 tons. The vehicle was designed to transport the M3 Stuart light tank, which weighed almost 13 tons, but could also be used for transporting the Cruiser Mk II A10, and Valentine tank.

The NR-5 variant had a Duplex TRD 37 gearbox, but was otherwise identical to the NR-3.

In NR-8, a new cab was introduced. The full metal cab was replaced with an open cabin that could be covered with a canvas roof.^[1]

The NR-9 to NR-13 variants were very similar to the NR-8. In the NR-14, produced in 1944, the rear wheels were dual (wheel size 11.00-24). Many copies of the NR-15 were shipped to Iran and played a key role in the transport of war materials to the Soviet Union via the Persian Corridor The two fuel tanks had a capacity of 280 liters (75 US-gallon) and were mounted on either side of the vehicle.^[1]

The NR-16 was in fact the last order placed during the war; 455 units were delivered in 1945. The order for the NR-17 was canceled at the end of World War II.^[1] After the war, the Americans ordered 600 units for the European armies then being re-established; Belgium and Netherlands each received 150 vehicles (NR-18 and NR-19) and France received 300 units (NR-20).^[1]

In total, 16 548 examples of the NR series were produced,^[1] and due to their good quality most remained in service until well after the war.^{[citation needed]}

This section needs expansion. You can help by adding to it. (March 2017)

The vehicle had a typical configuration, with a hooded front engine behind which there was a large driver cabin, and a rear cargo area.

In total, 16 548 vehicles were built, in 20 variants as described in the following table.^[1]

• List of U.S. military vehicles by supply catalog designation (G-528)
• List of U.S. military vehicles by model number
• Mack Trucks
• Mack model EH trucks
• Mack NJU
• Mack NM
• Mack NO

• Vanderveen, Bart (1998). A Record of Military Macks in the Services and Beyond. Wheels & tracks. After the Battle. ISBN 1-870067-09-6.

• Official Website

Wikimedia Commons has media related to Mack NR.