VVT-i

 

VVTL-i (Variable Valve Timing and Lift intelligent system) (also sometimes denoted as VVT-iL or Variable Valve Timing and Intelligence with Lift) is an enhanced version of VVT-i that can alter valve lift (and duration) as well as valve timing. It was introduced with the 2ZZ-GE found in the 1999 Toyota Celica. In the case of the 16-valve 2ZZ-GE, the engine head resembles a typical DOHC design, featuring separate cams for intake and exhaust and featuring two intake and two exhaust valves (four total) per cylinder. Unlike a conventional design, each camshaft has two lobes per cylinder, one optimized for lower rpm operation and one optimized for high rpm operation, with higher lift and longer duration. Each valve pair is controlled by one rocker arm, which is operated by the camshaft. Each rocker arm has a slipper follower mounted to the rocker arm with a spring, allowing the slipper-follower to freely move up and down with the high lobe without affecting the rocker arm. When the engine is operating below 6000-7000 rpm (dependent on year, car, and ECU installed), the lower lobe is operating the rocker arm and thus the valves, and the slipper-follower is freewheeling next to the rocker arm. When the engine is operating above the lift engagement point, the ECU activates an oil pressure switch which pushes a sliding pin under the slipper-follower on each rocker arm. The rocker arm is now locked into the slipper-follower's movements and thus follows the movement of the high rpm cam lobe and will operate with the high rpm cam profile until the pin is disengaged by the ECU. The lift system is similar in principle to Honda's VTEC operation. Toyota has ceased production of its VVTL-i engines in most markets, because it does not meet Euro IV specifications for emissions regulations. This includes the Corolla T-Sport (Europe), Corolla Sportivo (Australia), Celica, Corolla XRS, Matrix XRS, and the Pontiac Vibe GT, all of which had the 2ZZ-GE engine fitted. The Lotus Elise and Exige continued to offer the 2ZZ-GE engine until 2011, with the Exige offering the engine with a supercharger.

 

The Dual VVT-i system adjusts timing on both the intake and exhaust camshafts. It was introduced in 1998, on the Altezza RS200's 3S-GE engine. Dual VVT-i is also found in Toyota's 3.5-litre 2GR-FE V6 engine, first appearing on the 2005 Avalon. This engine can be found on numerous Toyota and Lexus models. By adjusting the valve timing, engine start and stop occurs almost unnoticeably at minimum compression. Fast heating of the catalytic converter to its light-off temperature is possible, thereby reducing hydrocarbon emissions considerably. Most Toyota engines including the 1LR-GUE (V10, used in the Lexus LFA), UR engines (V8), GR engines (V6), AR engines (large I4), ZR engines (medium I4), and NR engines (small I4) use this technology.

 

VVT-iE (Variable Valve Timing - intelligent by Electric motor) is a version of Dual VVT-i that uses an electrically operated actuator to adjust and maintain intake camshaft timing.^[1] The exhaust camshaft timing is still controlled using a hydraulic actuator. This form of variable valve timing technology was developed initially for Lexus vehicles. This system was introduced on the 1UR-FSE engine in the 2007 Lexus LS 460. The electric motor in the actuator spins together with the intake camshaft as the engine runs. To maintain camshaft timing, the actuator motor will operate at the same speed as the camshaft. To advance the camshaft timing, the actuator motor will rotate slightly faster than the camshaft speed. To retard camshaft timing, the actuator motor will rotate slightly slower than camshaft speed. The speed difference between the actuator motor and camshaft timing is used to operate a mechanism that varies the camshaft timing. The benefit of the electric actuation is enhanced response and accuracy at low engine speeds and at lower temperatures as well as a greater total range of adjustment. The combination of these factors allows more precise control, resulting in an improvement of both fuel economy, engine output and emissions performance.

 

VVT-iW (Variable Valve Timing - intelligent Wide) was introduced with the 2.0L turbocharged direct-injected 8AR-FTS fitted to the Lexus NX 200t. VVT-iW uses VVT-iW on the intake valves and VVT-i on the exhaust valves. The intake cam has mid-position cam lock mechanism that retards the continuously variable timing. It offers expanded valve opening angles (Wide) which enables the engine to operate in a modified-Atkinson cycle at low rpm for improved economy and lower emissions, and in the Otto cycle at high rpm for better performance, while delivering high torque throughout the rpm band.^[2]

 

The Valvematic system offers continuous adjustment to valve lift and timing and improves fuel efficiency by controlling the fuel/air intake using valve control rather than conventional throttle plate control.^[3] The technology made its first appearance in 2007 with the 3ZR-FAE engine in the Noah^[4] and later in early-2009 in the Avensis. This system is simpler in design compared to Valvetronic and VVEL, allowing the cylinder head to remain at the same height.

D-4 (standing for Direct Four Line) is a direct injection system used in a number of Toyota engines, sometimes referred to as VVT-i D-4. It appeared on the 1JZ-FSE and 2JZ-FSE engines found in some models of the Toyota Crown and Toyota Crown Majesta. It can also be found in several engines in the Toyota Avensis and Toyota RAV4.

 

D-4S is a twin injection fuel system combining both indirect and direct injection, using a traditional manifold fuel injector on one end for low pressure and a direct injector on the other for high pressure. It works in conjunction with VVT-i. This system debuted in the 2GR-FSE engine used in the Toyota Crown Athlete and the Lexus IS 350. This system was also used in the 4U-GSE (FA20) engine found in the 2012–2021 Toyota 86 and Subaru BRZ working in conjuction with Subaru's AVCS system, as well as the FA24D engine used in the 2022–present Toyota GR86 and Subaru BRZ, also working in conjunction with the AVCS system.

It is important to note that the "S" in the D-4S name does not signify a supercharged engine, as engines using the D-4S system such as the 4U-GSE and the 2GR-FSE do not have superchargers.

In 2010, Toyota USA announced a Limited Service Campaign (LSC 90K) to replace the rubber portion of the oil supply hose for the VVT-i actuator on the 2GR-FE (V6) engine, which were found to be defective. In all, approximately 1.6 million vehicles manufactured prior to 2008 were affected. The defective oil supply hoses were prone to degradation and eventual rupture, causing oil to rapidly leak and resulting in permanent engine damage. In 2014, the LSC 90K Campaign was extended to 31 December 2021^[5] on 117,500 Toyota brand vehicles that were "missed" during the initial campaign.

• Variable valve timing
• Variable valve lift
• Petrol direct injection (Toyota D-4 and D-4S)
• Variable-length intake manifold
• List of Toyota engines
  • Toyota AR engine
  • Toyota AZ engine
  • Toyota FZ engine
  • Toyota GR engine
  • Toyota JZ engine
  • Toyota LR engine
  • Toyota MZ engine
  • Toyota NZ engine
  • Toyota NR engine
  • Toyota UR engine
  • Toyota ZR engine
  • Toyota ZZ engine
• VTEC
• S-VT
• MIVEC
• Valvetronic