[go: up one dir, main page]

Jump to content

Amine oxide

From Wikipedia, the free encyclopedia

General structure of an amine oxide

In chemistry, an amine oxide, also known as an amine N-oxide or simply N-oxide, is a chemical compound that has the chemical formula R3N+−O. It contains a nitrogen-oxygen coordinate covalent bond with three additional hydrogen and/or substituent-groups attached to nitrogen. Sometimes it is written as R3N→O or, alternatively,[1] as R3N=O.

In the strict sense, the term amine oxide applies only to oxides of tertiary amines. Sometimes it is also used for the analogous derivatives of primary and secondary amines.

Examples of amine oxides include pyridine-N-oxide, a water-soluble crystalline solid with melting point 62–67 °C, and N-methylmorpholine N-oxide, which is an oxidant.

Applications

[edit]

Amine oxides are surfactants commonly used in consumer products such as shampoos, conditioners, detergents, and hard surface cleaners.[2] Alkyl dimethyl amine oxide (chain lengths C10–C16) is the most commercially used amine oxide.[3] They are considered a high production volume class of compounds in more than one member country of the Organisation for Economic Co-operation and Development (OECD); with annual production over 26,000, 16,000 and 6,800 tonnes (28,700, 17,600 and 7,500 short tons) in the US, Europe, and Japan, respectively.[2] In North America, more than 95% of amine oxides are used in home cleaning products.[4] They serve as stabilizers, thickeners, emollients, emulsifiers, and conditioners with active concentrations in the range of 0.1–10%.[2] The remainder (< 5%) is used in personal care, institutional, commercial products[5] and for unique patented uses such as photography.[2]

Lauryldimethylamine oxide, a fatty amine derivative, is a germicidal ingredient in many cosmetics.

Properties

[edit]

Amine oxides are used as protecting group for amines and as chemical intermediates. Long-chain alkyl amine oxides are used as amphoteric surfactants and foam stabilizers.

Amine oxides are highly polar molecules and have a polarity close to that of quaternary ammonium salts. Small amine oxides are very hydrophilic and have an excellent water solubility and a very poor solubility in most organic solvents.

Amine oxides are weak bases with a pKb of around 4.5 that form R3N+−OH, cationic hydroxylamines, upon protonation at a pH below their pKb.

Synthesis

[edit]

Almost all amine oxides are prepared by the oxidation of either tertiary aliphatic amines or aromatic N-heterocycles. Hydrogen peroxide is the most common reagent both industrially and in academia, however peracids are also important.[6] More specialised oxidising agents can see niche use, for instance Caro's acid or mCPBA. Spontaneous or catalysed reactions using molecular oxygen are rare. Certain other reactions will also produce amine oxides, such as the retro-Cope elimination, however they are rarely employed.

Reactions

[edit]

Amine oxides exhibit many kinds of reactions.[7]

in a 1,2-rearrangement:
Meisenheimer 1,2-rearrangement
or a 2,3-rearrangement:
Meisenheimer 2,3-rearrangement
Polonovski reaction

Metabolites

[edit]

Amine oxides are common metabolites of medication and psychoactive drugs. Examples include nicotine, Zolmitriptan, and morphine.

Amine oxides of anti-cancer drugs have been developed as prodrugs that are metabolized in the oxygen-deficient cancer tissue to the active drug.

Human safety

[edit]

Amine oxides (AO) are not known to be carcinogens, dermal sensitizers, or reproductive toxicants. They are readily metabolized and excreted if ingested. Chronic ingestion by rabbits found lower body weight, diarrhea, and lenticular opacities at a lowest observed adverse effect levels (LOAEL) in the range of 87–150 mg AO/kw bw/day. Tests of human skin exposure have found that after 8 hours less than 1% is absorbed into the body. Eye irritation due to amine oxides and other surfactants is moderate and temporary with no lasting effects.[2]

Environmental safety

[edit]

Amine oxides with an average chain length of 12.6 have been measured to be water-soluble at ~410 g/L. They are considered to have low bioaccumulation potential in aquatic species based on log Kow data from chain lengths less than C14 (bioconcentration factor < 87%).[2] Levels of AO in untreated influent were found to be 2.3–27.8 ug/L, while in effluent they were found to be 0.4–2.91 ug/L. The highest effluent concentrations were found in oxidation ditch and trickling filter treatment plants. On average, over 96% removal has been found with secondary activated sludge treatment.[3] Acute toxicity in fish, as indicated by 96h LC50 tests, is in the range of 1,000–3,000 ug/L for carbon chain lengths less than C14. LC50 values for chain lengths greater than C14 range from 600 to 1400 ug/L. Chronic toxicity data for fish is 420 ug/L. When normalized to C12.9, the NOEC is 310 ug/L for growth and hatchability.[3]

See also

[edit]

References

[edit]
  1. ^ Durrant, Marcus C. (2015). "A quantitative definition of hypervalency". Chemical Science. 6 (11): 6614–6623. doi:10.1039/C5SC02076J. PMC 6054109. PMID 30090275.
  2. ^ a b c d e f Organisation for Economic Co-operation and Development (OECD) (2006). "Amine Oxides". OECD Existing Chemicals Database. Archived from the original on 22 February 2014.
  3. ^ a b c Sanderson, H; C Tibazarwa; W Greggs; DJ Versteeg (2009). "High Production Volume Chemical Amine Oxides [C8–C20]". Risk Analysis. 29 (6): 857–867. doi:10.1111/j.1539-6924.2009.01208.x. PMID 19504658. S2CID 45774397.
  4. ^ Modler, RF; Inoguchi Y (2004). "CEH Marketing Research Report: Surfactants, Household Detergents, and their Raw Materials". Chemical Economics Handbook. Menlo Park, CA: SRI Consulting.
  5. ^ Sanderson, H; Counts JL; Stanton K; Sedlak R (2006). "Exposure and Prioritization—Human Screening Data and Methods for High Production Volume Chemicals in Consumer Products: Amine Oxides a Case Study". Risk Analysis. 26 (6): 1637–1657. doi:10.1111/j.1539-6924.2006.00829.x. PMID 17184403.
  6. ^ Smith, Michael B.; March, Jerry (2007), Advanced Organic Chemistry: Reactions, Mechanisms, and Structure (6th ed.), New York: Wiley-Interscience, p. 1779, ISBN 978-0-471-72091-1
  7. ^ Albini, Angelo (1993). "Synthetic utility of amine N-oxides". Synthesis. 1993 (3): 263–77. doi:10.1055/s-1993-25843.
  8. ^ Waldmann, T.; et al. (2012). "Oxidation of an Organic Adlayer: A Bird's Eye View". Journal of the American Chemical Society. 134 (21): 8817–22. doi:10.1021/ja302593v. PMID 22571820.
  9. ^ J. Meisenheimer, Ber. 52. 1667 (1919)
  10. ^ Smith, Michael B.; March, Jerry (2001). March's Advanced Organic Chemistry: Reactions, Mechanisms, and Structure (5th ed.). Wiley-Interscience. ISBN 0-471-58589-0.[page needed]
  11. ^ Grierson, D (1990). "The Polonovski Reaction". Org. React. 39: 85. doi:10.1002/0471264180.or039.02. ISBN 0471264180.
  12. ^ Polonovski, Max; Polonovski, Michel (1927). ""Sur les aminoxydes des alcaloïdes. III. Action des anhydrides et chlorures d'acides organiques. Préparation des bases nor."". Bull. Soc. Chim. Fr. 41: 1190–1208.
  13. ^ Kürti, Laszlo; Czako, Barbara (2005). Strategic Applications of Named Reactions in Organic Synthesis (paperback ed.). Elsevier Science. ISBN 0-12-429785-4.[page needed]
[edit]