[go: up one dir, main page]

Jump to content

Pentane

From Wikipedia, the free encyclopedia

This is the current revision of this page, as edited by 5.178.188.143 (talk) at 20:24, 2 November 2024 (Reactions). The present address (URL) is a permanent link to this version.

(diff) ← Previous revision | Latest revision (diff) | Newer revision → (diff)
Pentane
Skeletal formula of pentane
Skeletal formula of pentane with all explicit hydrogens added
Pentane 3D ball.png
Pentane 3D spacefill.png
Names
Preferred IUPAC name
Pentane[2]
Other names
Quintane;[1] Refrigerant-4-13-0
Identifiers
3D model (JSmol)
969132
ChEBI
ChEMBL
ChemSpider
DrugBank
ECHA InfoCard 100.003.358 Edit this at Wikidata
EC Number
  • 203-692-4
1766
MeSH pentane
RTECS number
  • RZ9450000
UNII
UN number 1265
  • InChI=1S/C5H12/c1-3-5-4-2/h3-5H2,1-2H3 checkY
    Key: OFBQJSOFQDEBGM-UHFFFAOYSA-N checkY
  • CCCCC
Properties[4]
C5H12
Molar mass 72.151 g·mol−1
Appearance Colourless liquid
Odor Gasoline-like[3]
Density 0.626 g/mL; 0.6262 g/mL (20 °C)
Melting point −130.5 to −129.1 °C; −202.8 to −200.3 °F; 142.7 to 144.1 K
Boiling point 35.9 to 36.3 °C; 96.5 to 97.3 °F; 309.0 to 309.4 K
40 mg/L (20 °C)
log P 3.255
Vapor pressure 57.90 kPa (20.0 °C)
7.8 nmol Pa−1 kg−1
Acidity (pKa) ~45
Basicity (pKb) ~59
UV-vismax) 200 nm
-63.05·10−6 cm3/mol
1.358
Viscosity 0.240 mPa·s (at 20 °C)
Thermochemistry
167.19 J K−1 mol−1
263.47 J K−1 mol−1
−174.1–−172.9 kJ mol−1
−3.5095–−3.5085 MJ mol−1
Hazards
GHS labelling:
GHS02: Flammable GHS07: Exclamation mark GHS08: Health hazard GHS09: Environmental hazard
Danger
H225, H304, H336, H411
P210, P261, P273, P301+P310, P331
NFPA 704 (fire diamond)
NFPA 704 four-colored diamondHealth 1: Exposure would cause irritation but only minor residual injury. E.g. turpentineFlammability 4: Will rapidly or completely vaporize at normal atmospheric pressure and temperature, or is readily dispersed in air and will burn readily. Flash point below 23 °C (73 °F). E.g. propaneInstability 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g. liquid nitrogenSpecial hazards (white): no code
1
4
0
Flash point −49.0 °C (−56.2 °F; 224.2 K)
260.0 °C (500.0 °F; 533.1 K)
Explosive limits 1.5–7.8%[3]
Lethal dose or concentration (LD, LC):
  • 3 g kg−1 (dermal, rabbit)
  • 5 g kg−1 (oral, mouse)
130,000 mg/m3 (mouse, 30 min)
128,200 ppm (mouse, 37 min)
325,000 mg/m3 (mouse, 2 hr)[5]
NIOSH (US health exposure limits):
PEL (Permissible)
TWA 1000 ppm (2950 mg/m3)[3]
REL (Recommended)
TWA 120 ppm (350 mg/m3) C 610 ppm (1800 mg/m3) [15-minute][3]
IDLH (Immediate danger)
1500 ppm[3]
Related compounds
Related alkanes
Supplementary data page
Pentane (data page)
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
checkY verify (what is checkY☒N ?)

Pentane is an organic compound with the formula C5H12—that is, an alkane with five carbon atoms. The term may refer to any of three structural isomers, or to a mixture of them: in the IUPAC nomenclature, however, pentane means exclusively the n-pentane isomer, in which case pentanes refers to a mixture of them; the other two are called isopentane (methylbutane) and neopentane (dimethylpropane). Cyclopentane is not an isomer of pentane because it has only 10 hydrogen atoms where pentane has 12.

Pentanes are components of some fuels and are employed as specialty solvents in the laboratory. Their properties are very similar to those of butanes and hexanes.

Isomers

[edit]
Common name normal pentane
unbranched pentane
n-pentane
isopentane neopentane
IUPAC name pentane 2-methylbutane 2,2-dimethylpropane
Molecular diagram
Skeletal diagram
Melting point (°C)[6] −129.8 −159.9 −16.6
Boiling point (°C)[6] 36.0 27.7 9.5
Density
(0 °C,kg/m3)[6]
621 616 586

Industrial uses

[edit]

Pentanes are some of the primary blowing agents used in the production of polystyrene foam and other foams. Usually, a mixture of n-, i-, and increasingly cyclopentane is used for this purpose.

Acid-catalyzed isomerization gives isopentane, which is used in producing high-octane fuels.[7]

Because of their low boiling points, low cost, and relative safety, pentanes are used as a working medium in geothermal power stations and organic Rankine cycles. It is also used in some blended refrigerants.

Pentanes are solvents in many ordinary products, e.g. in some pesticides.[8]

Laboratory use

[edit]

Pentanes are relatively inexpensive and are the most volatile liquid alkanes at room temperature, so they are often used in the laboratory as solvents that can be conveniently and rapidly evaporated. However, because of their nonpolarity and lack of functionality, they dissolve only nonpolar and alkyl-rich compounds. Pentanes are miscible with most common nonpolar solvents such as chlorocarbons, aromatics, and ethers.

They are often used in liquid chromatography.

Physical properties

[edit]

The boiling points of the pentane isomers range from about 9 to 36 °C. As is the case for other alkanes, the more thickly branched isomers tend to have lower boiling points.

The same tends to be true for the melting points of alkane isomers, and that of isopentane is 30 °C lower than that of n-pentane. However, the melting point of neopentane, the most heavily branched of the three, is 100 °C higher than that of isopentane. The anomalously high melting point of neopentane has been attributed to the tetrahedral molecules packing more closely in solid form; this explanation is contradicted by the fact that neopentane has a lower density than the other two isomers,[9] and the high melting point is actually caused by neopentane's significantly lower entropy of fusion.

The branched isomers are more stable (have lower heat of formation and heat of combustion) than n-pentane. The difference is 1.8 kcal/mol for isopentane, and 5 kcal/mol for neopentane.[10][11]

Rotation about two central single C-C bonds of n-pentane produces four different conformations.[12]

Reactions

[edit]

Like other alkanes, pentanes are largely unreactive at standard room temperature and conditions - however, with sufficient activation energy (e.g., an open flame), they readily oxidize to form carbon dioxide and water:

C5H12 + 8 O2 → 5 CO2 + 6 H2O + heat/energy

Like other alkanes, pentanes undergo free radical chlorination:

C5H12 + Cl2 → C5H11Cl + HCl

Without zeolite catalysts, such reactions are unselective, so with n-pentane, the result is a mixture of the 1-, 2-, and 3-chloropentanes, as well as more highly chlorinated derivatives. Other radical halogenations can also occur.

Production and occurrence

[edit]

Pentane is produced by fractional distillation of petroleum and purified by rectification (successive distillations).[13]

It occurs in alcoholic beverages and in hop oil.[13] It is a component of exhaled breath for some individuals. A degradation product of unsaturated fatty acids, its presence is associated with some diseases and cancers.[14]

References

[edit]
  1. ^ Hofmann, August Wilhelm Von (1 January 1867). "I. On the action of trichloride of phosphorus on the salts of the aromatic monamines". Proceedings of the Royal Society of London. 15: 54–62. doi:10.1098/rspl.1866.0018. S2CID 98496840.
  2. ^ International Union of Pure and Applied Chemistry (2014). Nomenclature of Organic Chemistry: IUPAC Recommendations and Preferred Names 2013. The Royal Society of Chemistry. p. 59. doi:10.1039/9781849733069. ISBN 978-0-85404-182-4.
  3. ^ a b c d e NIOSH Pocket Guide to Chemical Hazards. "#0486". National Institute for Occupational Safety and Health (NIOSH).
  4. ^ Record of n-Pentane in the GESTIS Substance Database of the Institute for Occupational Safety and Health, accessed on 19 April 2011.
  5. ^ "n-Pentane". Immediately Dangerous to Life or Health Concentrations (IDLH). National Institute for Occupational Safety and Health (NIOSH).
  6. ^ a b c Wei, James (1999). "Molecular Symmetry, Rotational Entropy, and Elevated Melting Points". Industrial & Engineering Chemistry Research. 38 (12): 5019–5027. doi:10.1021/ie990588m.
  7. ^ Karl Griesbaum; Arno Behr; Dieter Biedenkapp; Heinz-Werner Voges; Dorothea Garbe; Christian Paetz; Gerd Collin; Dieter Mayer; Hartmut Höke (2002). "Hydrocarbons". Ullmann's Encyclopedia of Industrial Chemistry. Weinheim: Wiley-VCH. doi:10.1002/14356007.a13_227. ISBN 978-3-527-30673-2.
  8. ^ Milne, G. W. A., ed. (2005). Gardner's Commercially Important Chemicals: Synonyms, Trade Names, and Properties. Hoboken, New Jersey: John Wiley & Sons, Inc. p. 477. ISBN 978-0-471-73518-2.
  9. ^ Wei, James (1999). "Molecular Symmetry, Rotational Entropy, and Elevated Melting Points". Industrial & Engineering Chemistry Research. 38 (12). American Chemical Society (ACS): 5019–5027. doi:10.1021/ie990588m. ISSN 0888-5885.
  10. ^ From the values listed at Standard enthalpy change of formation (data table).
  11. ^ Good, W.D (1970). "The enthalpies of combustion and formation of the isomeric pentanes". The Journal of Chemical Thermodynamics. 2 (2). Elsevier BV: 237–244. doi:10.1016/0021-9614(70)90088-1. ISSN 0021-9614.
  12. ^ Roman M. Balabin (2009). "Enthalpy Difference between Conformations of Normal Alkanes: Raman Spectroscopy Study of n-Pentane and n-Butane". J. Phys. Chem. A. 113 (6): 1012–9. Bibcode:2009JPCA..113.1012B. doi:10.1021/jp809639s. PMID 19152252.
  13. ^ a b "Pentane". PubChem. Retrieved 2023-06-29.
  14. ^ Phillips, Michael; Herrera, Jolanta; Krishnan, Sunithi; Zain, Mooena; Greenberg, Joel; Cataneo, Renee N. (1999). "Variation in volatile organic compounds in the breath of normal humans". Journal of Chromatography B: Biomedical Sciences and Applications. 729 (1–2): 75–88. doi:10.1016/S0378-4347(99)00127-9. PMID 10410929.
[edit]