- Home
- Product Categories
- Headers
- Extended GPIO Female Header - 2x20 Pin (16mm/7.30mm)
Extended GPIO Female Header - 2x20 Pin (16mm/7.30mm)
This 2x20 pin female header is meant to allow you to extend the reach of any board with the standard 2x20 GPIO pin footprint like the Raspberry Pi, Google Coral, and NVIDIA Jetson. You can also solder it to Pi HATs that do not have headers on the board. This is assuming that the board is only populated on the top of the board or the height of the components do not get in the way if it is a two layer board.
The pin header is 16mm in height and the pin length is 7.30mm. This header also has standard 0.1" spacing.
Note: Please note that this product is just the header. The Raspberry Pi, enclosure, Pi Wedge, and breadboard are sold separately.
Extended GPIO Female Header - 2x20 Pin (16mm/7.30mm) Product Help and Resources
Preassembled 40-pin Pi Wedge Hookup Guide
October 29, 2015
Using the Preassembled Pi Wedge to prototype with the Raspberry Pi B+.
Raspberry Pi 4 Kit Hookup Guide
March 14, 2020
Guide for hooking up your Raspberry Pi 4 Model B basic, desktop, or hardware starter kit together.
Core Skill: Soldering
This skill defines how difficult the soldering is on a particular product. It might be a couple simple solder joints, or require special reflow tools.
Skill Level: Noob - Some basic soldering is required, but it is limited to a just a few pins, basic through-hole soldering, and couple (if any) polarized components. A basic soldering iron is all you should need.
See all skill levels
Comments
Looking for answers to technical questions?
We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.
Customer Reviews
No reviews yet.